CNC, 3D Printer, Stepper Motors
Showing all 3 results
-
CNC, 3D Printer, Stepper Motors, Robotics, Motor Driver, IR, Robotics, Motors, CNC, 3D Printer, Pumps, Sensors, Breakout Boards, Shields & Modules
Cnc Shield For Arduino V3 Engraver
CNC, 3D Printer, Stepper Motors, Robotics, Motor Driver, IR, Robotics, Motors, CNC, 3D Printer, Pumps, Sensors, Breakout Boards, Shields & ModulesCnc Shield For Arduino V3 Engraver
- This expansion board as a driver expansion board, can be used for engraving machines, 3D printers.
- It is a total of four slots, can drive four A4988 stepper motor. Each road stepper motors only need two IO ports. In other words, six IO ports can be well managed three stepper motors. Very convenient to use.
- UNO for Arduino module IO port correspondence introduction.
- IO corresponding figure above
- UNO for Arduino———————- expansion board
- 8 ———————— EN ( stepper motor driver enable , active low )
- 7 ———————– Z.DIR (Z -axis direction control )
- 6 ———————– Y.DIR (Y -axis direction control )
- 5 ———————– X.DIR (X -axis direction control )
- 4 ———————- Z.STEP (Z -axis stepper control )
- 3 ———————- Y.STEP (Y -axis stepper control )
- 2 ———————- X.STEP (X -axis stepper control )
SKU: n/a -
CNC, 3D Printer, Stepper Motors, Robotics, Motor Driver, IR, Robotics, Motors, CNC, 3D Printer, Pumps, Sensors, Breakout Boards, Shields & Modules
Stepper Motor 28Byj-48 5V + Uln2003 Motor Driver Board
CNC, 3D Printer, Stepper Motors, Robotics, Motor Driver, IR, Robotics, Motors, CNC, 3D Printer, Pumps, Sensors, Breakout Boards, Shields & ModulesStepper Motor 28Byj-48 5V + Uln2003 Motor Driver Board
- Rated Voltage: DC5V 4-phase
- Step angle: 5.625 x 1/64
- DC Resistance: 200??7% (25C)
- Insulation Resistance: >10M? (500V)
- Dielectric Strength: 600V AC / 1mA / 1s
- Insulation Grade: A
- No-load Pull in Frequency: >600Hz
- No-load Pull out Frequency: >1000Hz
- Pull in Torque: >34.3mN.m(120Hz)
- Detent Torque: >34.3mN.m
- Temperature Rise:
SKU: n/a